Vw jetta tdi turbo boost gauge kit install#
Vw jetta tdi turbo boost gauge kit driver#

Carefully pry each of the tabs to release and remove the trim cover from the vent housing Step 10:.Locate the retaining tabs on the open/close wheel trim cover (Fig: 2.9).When all tabs have been released, pull the LH vent housing off of the trim panel.

The tabs can be easily broken, so work slowly and methodically while releasing them.

Carefully pry up on each of the tabs to release the LH vent housing from the trim panel.

NOTE: The next several steps were taken with the trim panel removed for clarity, but you can perform all of these steps with the panel flipped down as shown in Fig: 2.4.

Some of the tabs are not shown in the photo as they run around the entire perimeter of the vent.

Locate all of the tabs which secure the LH vent housing to the dashboard trim panel.

Swing the wires aside so they are out of the way.

Release the electrical connectors from behind the center vent assembly.

A blanket or cloth can be placed on top of the steering column to protect the panel from scratches.

It is still connected to the top of the steering column with a fabric trim piece.

When all clips are released, tip the front of the panel forward slightly, but don’t remove it.

The dashboard trim panel can be easily broken, so work slowly and methodically while releasing it.

Pry gently around the entire perimeter of the dashboard trim panel with a non-marring trim removal tool, releasing all of the plastic snap retainers as you go along (highlighted with arrows in Fig: 2.3).

The surrounding trim will come out with the vent, so work carefully to avoid stressing the plastic.

Reach around and push from the rear to pop the left side vent out of the dash.

Pop the panel from its snap-clip fasteners and lay it aside.

Pry on the front edge of the left dashboard side panel with a non-marring trim removal tool.Section 2: Installing the Vent Pod and Gauge Step 1: Route and secure all hoses, harnesses, and the transducer itself in order to avoid interference with moving parts such as the steering shaft and pedals. The transducer wiring harness will be routed to the gauge later.

Vw jetta tdi turbo boost gauge kit install#

Install the moisture filter between the vacuum source and the transducer.

Inside the cabin, pierce a hole in the grommet near the foot rest (Fig: 1.2), then pull the hose through.

The small silicone vacuum line connected to the boost tap is then routed through the engine compartment to a grommet in the firewall, where it enters the cabin. Engine vacuum/boost is sampled from a boost tap on the engine (not included with all kits).

The illustration below shows kit component general locations and connections. Installation: Section 1: Installing the Boost Tap/Routing the Vacuum Line Step 1:

Vw jetta tdi turbo boost gauge kit driver#

Our vent pod is compatible with most 52mm (2 1/16″) boost gauges, and it angles the gauge towards the driver so you can monitor your boost levels without taking your eyes off the road! Part Numbers: ES3183947, ES3247336 Looking to add style and function to your dash? Look no further, ECS Tuning has designed a vent pod which will seamlessly integrate into the dash of your MK6 Jetta for a factory appearance.